How To Light A Pilot Light On A Trane Furnace

How To Light A Pilot Light On A Trane Furnace. This video is part of the heating and cooling series of training videos made to accompany my web. Access the furnace controls by opening the metal door at the bottom front side of the trane furnace.

Pilot Light Goes Out When Turned To On Keepyourmindclean
Pilot Light Goes Out When Turned To On Keepyourmindclean from keepyourmindclean.blogspot.com

Does my trane furnace have a pilot light? Steps for relighting the furnace pilot light. Turn the gas valve to the “off” setting.

Access The Furnace Controls By Opening The Metal Door At The Bottom Front Side Of The Trane Furnace.

This one covers how to light the pilot on the gas furnace. This video is part of the heating and cooling series of training videos made to accompany my web. Once you are sure the pilot light is on, release your pressure on the reset button.

Turn The Gas Valve To The “Off” Setting.

This is usually red and should have settings for “off,” “on,” and “pilot.”. Steps for relighting the furnace pilot light. Access the furnace controls by opening the metal door at the bottom front side of the trane furnace.

These Steps Outline The Standard Procedure For Relighting A Standing Pilot Light On A Gas Furnace.

Others may be held by screws. After locating the reset button, it’s time to turn the knob of the furnace to pilot. After that, press the reset button for a while and use a long lighter flame near the opening of the pilot light.

How To Light A Pilot Light On A Trane Furnace Set The Central Furnace Thermostat To 'Off' Or The Lowest Temperature Option.

If the flame won't keep burning, consider a service call. The xe80 furnace is an 80% furnace and you cannot light it manually. Keep the knob in for 20 seconds and then release it and turn it to the on position.light the pilot on a trane furnace by holding a flame to the orifice while holding in the gas control.locate the pilot light the gas control valve and the control knob aren’t in the exact same place on every model, but they are usually easily accessible, although you often have to remove.

Access The Furnace Controls By Opening The Metal Door At The Bottom Front Side Of The Trane Furnace.

Some panels simply lift off; If the ignitor will not glow, it is because: When you realize that you relight the pilot light, release the button.

Leave a Reply

Your email address will not be published.